Colorfabb Carbon Fibre PA-CF Low Warp

Colorfabb Carbon Fibre PA-CF Low Warp - Imaginables | Ultimaker & Dremel 3D Printers
  • Colorfabb Carbon Fibre PA-CF Low Warp
  • Colorfabb Carbon Fibre PA-CF Low Warp
  • Colorfabb Carbon Fibre PA-CF Low Warp
  • Colorfabb Carbon Fibre PA-CF Low Warp
  • Colorfabb Carbon Fibre PA-CF Low Warp


$119.95  Incl. GST

The PA-CF Low Warp is a one of a kind polyamide formulation with the ability to print nearly warp free on non heated buildplatforms. Low infill prints come out perfectly flat on cold bed for higher infill prints 40/50C temperature is enough to obtain flat prints.

PA-CF low warp is infused with carbon fibre for increased stiffness. Users are recommended to use wear resistant nozzles, such as Olsson Ruby.

PA-CF Low Warp excels in tensile and impact strength and allows continues use at 120°C while retaining sufficient mechanical properties.

The formulation has been modified to reduce uptake of moisture and it also takes about 4 times longer to reach the saturation point compared to unmodified PA6. This makes PA-CF Low Warp less affected by moisture then most other nylon filaments available in the market.

CARBON FIBRE IS ABRASIVE

A special point of attention is the abrasive nature of the carbon fibres. In general these fibres will accelerate the nozzle-wear of brass nozzles, much faster than unfilled filaments. ColorFabb recommends to using wear resistant nozzles, such as Olsson Ruby nozzle.

Due to high stiffness of 2.85mm filament we recommend users to use spoolmounts which have some friction between spool and holder, to prevent unspooling of filament.

Read more about print settings and advice here.

Please read our Safety and Compliance information regarding printing materials.



Related Products

Ultimaker TPU 95A
$109.90
Ultimaker TPU 95A

Ultimaker TPU 95A

Weight: 0.75kg  Diameter: 2.85mm ULTIMAKER TPU 95A: WEAR AND TEAR RESISTANT Ultimaker TPU 95A is an easy and fast to print filament with a nice balance of flexibility, wear and ...

$109.90
×
Ultimaker Tough PLA
$79.90
Ultimaker Tough PLA

Ultimaker Tough PLA

Ultimaker Tough PLA Weight: 0.75kg Diameter: 2.85mm Length: Approximately 90m long Ultimaker Tough PLA combines impact, tensile and flexural strength similar to ABS, all with th...

$79.90
×
Ultimaker PVA - 750g
$154.90
Ultimaker PVA - 750g

Ultimaker PVA - 750g

PVA (Polyvinyl Alcohol) is a water soluble support material for multi-extrusion 3D printing. With a good thermal stability, Ultimaker PVA is ideal for printing complex models t...

$154.90
×