This grease can be used for lubrication of the lead screw of the Z motor according to the maintenance schedule, please ensure that existing grease on the parts are cleaned off p...
Calibration Card
Tube Coupling Collet for your Ultimaker Bowden Tube Replacing the TUBE Collet - Instructions
Clamp Clip- White Did you know you can also 3D Print these clips? You can download the STL File of the clamp clips from here, and print as many as you like. We recommend using T...
The Bowden tube, 70.5 cm long. Made from PFA. Outside diameter 0.25 inch, inside 0.125 inch is used to transport the filament to the extruder head. Includes two white Clamp Clip...
Linear bearings for the Print head, compatible with Ultimaker 2 Ultimaker 2 Extended Ultimaker 2+ Ultimaker 2 Extended+ Ultimaker 2 Go UMO UMO+
Linear Bearing LM12LUU for Ultimaker Original
***THIS Coupler IS FOR Ultimaker ORIGINAL and ORIGINAL +*** Feeder Quick Fit Coupling for your Material feeder
Ultimaker Feeder motor Part no 1017 Compatible with Ultimaker Original Ultimaker Original+
UMO (1027)- Rigid Shaft Coupling for Ultimaker Original
Z linear shaft for your Ultimaker Original and Original+
Injection Moulding Set, This product is compatible with the Ultimaker Original and the Ultimaker Original+.
UMO (1048)- Print Head Hot End Holder
Part 1052- The heater cartridge is being used to heat your hot end. This part is compatible with the complete Ultimaker Original 18V 40W and it is NOT for an Ultimaker Original +
Ultimaker Original Thermocouple Transmitter ( Only for Ultimaker Original)
Part 1073- The Thermo Couple Sensor is used to measure the heat from your Hot End. This part is compatible with the complete Ultimaker Original.
UMO (1081)- Z Motor for Ultimaker Original
Short Timing Belt for Ultimaker Original and Original+. This is NOT compatible with the Ultimaker 2 or 2+ **Only one Belt**
Long Timing Belt for Ultimaker Original and Original+. This is NOT compatible with the Ultimaker 2 or 2+ **Only one Belt**
Ultimaker Original Stepper Driver x 4 ( Only for Ultimaker Original)
Build Platform Acrylic Bed for your Ultimaker Original
UltiController Knob for your Ultimaker Original. This product is compatible with the Ultimaker Original and the Ultimaker Original+.
Controller Module for your UltiController.
Belt Pack for the Ultimaker Original and Original+. Includes 2 x Short Belts (Part 1085) 4 x Long Belts (Part 1086) This is NOT compatible with the Ultimaker 2 or 2+
Ultimaker Original Knurled Drive Bolt Kit for your Material Feeder( Only for Ultimaker Original and Original+)
Fan Pack for the UMO and UMO+ includes 1501 Print Head Fancap Metal 1512 Print Head Fan 24V DC
Total $0.00