UMO (1048)- Print Head Hot End Holder

Part 1052- The heater cartridge is being used to heat your hot end. This part is compatible with the complete Ultimaker Original 18V 40W and it is NOT for an Ultimaker Original +

Ultimaker Original Thermocouple Transmitter ( Only for Ultimaker Original)

Part 1073- The Thermo Couple Sensor is used to measure the heat from your Hot End. This part is compatible with the complete Ultimaker Original.

UMO (1081)- Z Motor for Ultimaker Original

Short Timing Belt for Ultimaker Original and Original+. This is NOT compatible with the Ultimaker 2 or 2+ **Only one Belt**

Long Timing Belt for Ultimaker Original and Original+. This is NOT compatible with the Ultimaker 2 or 2+ **Only one Belt**

Ultimaker Original Stepper Driver x 4 ( Only for Ultimaker Original)

Build Platform Acrylic Bed for your Ultimaker Original

UltiController Knob for your Ultimaker Original. This product is compatible with the Ultimaker Original and the Ultimaker Original+.

Main Cables for your Ultimaker Original

Controller Module for your UltiController.

Belt Pack for the Ultimaker Original and Original+. Includes 2 x Short Belts (Part 1085) 4 x Long Belts (Part 1086) This is NOT compatible with the Ultimaker 2 or 2+

The hot end bundle is fool proof when assembling. There is only one way to assemble it, no (more) small differences. It is leak free, so no need to use teflon tape or ABS to mak...

Ultimaker Original Knurled Drive Bolt Kit for your Material Feeder( Only for Ultimaker Original and Original+)

Part 1513- The heater cartridge 24V 40W is being used to heat your hot end. This part is compatible with the complete Ultimaker Original +.  ** It is not Compatible with the Ult...

Fan Pack for the UMO and UMO+ includes 1501 Print Head Fancap Metal 1512 Print Head Fan 24V DC    

Part 2225 -  PT100 B Sensor. This is the Ultimaker Original+ PT100 B Sensor. It does the temperature reading in the hot end. Length 150cm

The axial fan at the front of the print head spins when one of the print cores is above 40 ºC. This helps to prevent the heat from the nozzle traveling too far upwards. Without ...